Showing 13–24 of 39 results

  • $0.85

    This 1/8 inch fill line black is sold by the foot. It is designed to be used in conjunction with the push to connect injectors certified for use with Contrail Rockets motors. Several feet should extend out of the nozzle to prevent damage to your fill fitting.


  • $100.00

    This 1/8 NPT is designed to thread into the top bulkhead where either the vent is removed or where a staging port has been provided. It is a 3000 psi rated valve and requires that the top motor is vented out the top bulkhead. The use of a 1/8 NPT close nipple and press lock fitting to connect to second stage are also required.


  • $30.00

    This 1/8 inch NPT fitting is designed to thread into the top bulkhead of Contrail Rockets motors. It is also used where the motor is vented thru the combustion chamber. When this is don the vent needs to be secured so it can be seen when venting and also to prevent it’s loss. This fitting can be used hundreds of times push the green ring and push in the hose once released remove hose while still depressing the green release ring.


  • $0.85

    This 1/8 vent line clear is sold by the foot. It is designed to be used in conjunction with the push to connect injectors certified for use with Contrail Rockets motors.


  • $1.00

    This .125 mW resistor igniter is non-hazmat an is designed for the 29 mm motors only is requires the use of a voltage reduction clip to be installed in line with the igniter leads. Failure to use a set of four 10 ohm resistors in line will result in igniter burn out without igniting the Pyrodex Pellet.


  • $5.00

    This device is designed for use with the .125 mW resistor used in the 29 mm motors system.


  • $1.00

    This .250 mW 12 volt resistor igniter is non-hazmat and designed for the 38 mm motors or larger single fill with the Pyrodex Pellet method developed by Contrail Rockets. This can be used on larger rockets but the 24 volt system is recommended.


  • $1.50

    This .250 mW 12 volt resistor igniter is non-hazmat and designed for the 38 mm motors or larger single fill with the Pyrodex Pellet method developed by Contrail Rockets. This can be used on larger rockets but the 24 volt system is recommended.


  • $1.00

    This .500 mW 24 volt resistor igniter is non-hazmat and is developed for the use in Contrail Rockets motors using the Pyrodex Pellet method developed by Contrail Rockets.


  • $1.50

    This .500 mW 24 volt resistor igniter is non-hazmat and is developed for the use in Contrail Rockets motors using the Pyrodex Pellet method developed by Contrail Rockets. This is the igniter used for the largest Contrail Rockets motors including the O-6300 which uses 7 igniters one on each injector.


  • $1.35

    This 3/16 inch line black is sold by the foot. It is designed to be used in conjunction with the push to connect injectors certified for use with Contrail Rockets motors. Several feet should extend out of the nozzle to prevent damage to your fill fitting.


  • $3.50

    This 3/8 inch fill line black is sold by the foot. It is designed to be used in conjunction with the push to connect injectors certified for use with Contrail Rockets motors. Several feet should extend out of the nozzle to prevent damage to your fill fitting.